1. The life span of the batteries depends on how often you use the product.
2. The levels can be altered by use of up & down button.
3. This product is for pet training only , Training sessions should be kept positive and short, about 10-15 minutes each time.
4. this product is the most effective and safest tool for pet training.
How to Use the Transmitter
1. To turn on/off the Transmitter, Press the mode button on the Transmitter for 5 seconds.
2. By pressing the Mode button to change to different modes --- -the LCD images will change.
3. Press the up and down buttons on right hand side to set level.
4. Choose the different channels for different receivers.
5. The Transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.
6.1n STANDBY MODE, press any button (except LED light button) to wake it up.
Connect the Transmitter with the Collar Receiver
1. Turn on the Transmitter and choose 1or 2 channels to encode.
2. Lift the Reset part of the Rubber cover in the Collar Receiver.
3. Use a toothpick or paper click to insert into the Reset HOLE inside the Collar Receiver.
4. Press the LAUNCH button on the Transmitter immediately while you are hearing a beep from the collar.
5. The Collar Receiver will beep , it means that the Transmitter has encoded the collar.
6. After completion, put the rubber cover in the right position to keep the internal unit from dust and water.
1 x remote control unit
2 x collars
1 x USB cord
2 x test light & replacement probes
1 x Operating Instructions
Note: Please use 5V, 0.5A adapter to charge the remote, the voltage of output cannot exceed 5V.
Please search B00OTGAON4 for new version with bird whistle function;
Please search B00J7JVD7E for waterproof version